Return to the BUILD
“Fit the interior light switch to the right door sill liner and fix it in place with a bracket. Then fit the sill liner into the main body shell.”
Contents
Parts
- 67A – Right Door Sill Liner
- 67B – Door Switch Bracket
- 2x CM screws (+1 spare)
- 2x HP screws (+1 spare)
Materials: All of these parts are plastic.
Magazine – Issue 18
- Assembly Guide: Model Instructions
- Track Legends: Ferrari 512 BB, Porsche 904, Alfa Romeo 8C
- The Story of Motorsports: Transmission and Clutch, The Seat Belt
- Challenging Circuits: Laguna Seca
Build
The Right Door Sill Liner
Step 01
Retrieve your Body assembly from the previous phase. Fit the unconnected switch on the Door Switches and Wires to this matching square hole on the Right Door Sill Liner.
The orientation of the unconnected pin on the switch doesn’t matter here:
Fit the Door Switch Bracket on top of the switch (and covering the two posts), and secure it down with two (2) HP screws.
The flat surface of the Door Switch Bracket should be facing away from the switch:
Step 02
Carefully turn your Body assembly upside down. Fit this Right Door Sill Liner into place at the right door, as shown.
As always, I recommend taping the doors closed to protect the hinges when turning this body over. As before, ensure this pin (circled below) of the Right Door Sill Liner fits into the matching hole of the Front Roof Liner:
Secure the Right Door Sill Liner into place with two (2) CM screws.
This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:
There is a pin on the bottom of the Right Door Inner Panel that should push on this switch when the door is closed:
Thoughts
This process was the same as in the previous phase. Nothing new to mention here!
Next Up
Phase 68 – Body: Rear Bumper/Overriders, License Plate Lamps