Return to the BUILD

“Fit the rear window to the roof module.”




  • 55A – Rear Window
  • 2x CM screws (+1 spare)

Materials: This Rear Window is made of SAN (Styrene-AcryloNitrile resin).

Magazine – Issue 15

  • Assembly Guide: Model Instructions
  • Track Legends: BMW 328, Wiesmann GT, Maserati A6
  • The Story of Motorsports: Safety on the Circuit, Ford in Competition
  • Ace Racers: Fritz Huschke von Hanstein
  • Challenging Circuits: Peking-Paris 1907


The Rear Window

NOTE: Eaglemoss recommends wearing gloves while installing these clear parts to avoid leaving fingerprints.

Step 01

Retrieve your Roof assembly from the previous phase. Fit the two tabs along the top edge of the Rear Window over the matching screw holes inside the rear top edge of the Roof assembly, as shown.

These two rounded mounting tabs kind of snap under the roof and over the posts of the screw holes, aligning the window perfectly:

Secure the Rear Window to the Roof from the interior with two (2) CM screws. Do not over-tighten these screws, it can crack the plastic.

This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:

We can still store and protect this assembly in the shipping clamshell, it just doesn’t fit as well:


Another simple phase to complete. I am looking forward to seeing this Roof mounted on the body.

Next Up

Phase 56 – Body: Main Body Shell

Leave a Reply

Your email address will not be published. Required fields are marked *