PHASES 01-10

This is just a page to group the phases by ten each. Please use the menus above or the direct links below:

  • Phase 01 – Body: Hood, Radiator Grille/Mesh
  • Phase 02 – Wheels: Front Tire/Wheel, Brake Drum/Line, Hubcap (Single)
  • Phase 03 – Interior: Dashboard, Turn Signals and Windshield Wiper Stalks, Gauges, Steering Wheel/Column
  • Phase 04 – Engine: Left Engine Block, Fuel Injection Pump/Shaft/Pipes, Flywheel Cover
  • Phase 05 – Body: Front Bumper, License Plate, Overriders
  • Phase 06 – Engine: Crankcase, Oil Filter, Oil Radiator Cover/Tank/Pipe
  • Phase 07 – Engine: Cylinder Head, Front/Rear Exhaust Manifolds, Front Seals
  • Phase 08 – Engine: Intake Manifold, Heat Shield, Air Intake Tune, Compressor Intake
  • Phase 09 – Engine: Cylinder Head Cover, Tensioning Screws, Ignition Cables/Duct, Distributor and Cables
  • Phase 10 – Engine: Right Engine Block, Dynamo, Pulley, Support Plate, Water Pump

Building the 1:8 scale Mercedes-Benz 300 SL from Eaglemoss